The marks left by the double-sided foam tape for a long time are difficult to remove. When you want to wipe it off, it is not easy to wipe it off, and it will always leave a black mark. So how to remove the double-sided foam tape?
1. For the imprint on the wall, use a hair dryer to heat it, and it can be easily removed. 2. If you have left a black mark, you can apply white flower oil on it, then wipe it with a rag and wash it with water. If you don’t have white flower oil, you can also use Fengyoujing or Chinese Traditional Chinese Medicine to rub it over and over again.
3. If the area of the adhesive sticker is not large, wipe it with an eraser. If the area is larger, apply industrial alcohol first, and then wipe it with a dry cloth.
4. Soak the dry cloth with vinegar, wring it out, and cover the entire trace area of the foam glue. After the foam double-sided adhesive is completely penetrated, gently scrape it off with a ruler.
Different methods of foam double-sided tape in different places
1. If it is pasted on the wall, you can scrape off a small corner with a sharp object, and then press the small corner with your hand to tear it down. Although it is a little troublesome, it will not leave a trace.
2. If it is attached to the plastic, soak it in hot water with a towel, and then cover the area with the double-sided foam tape. After the double-sided foam tape is fully penetrated, open a small corner and slowly scrape it off.
3. If it is pasted on the glass, take an appropriate amount of decontamination powder and put it on a semi-wet rag, and wipe it back and forth several times. If it is a long time and the mark is harder, you can first soak the mark in water and then use the decontamination powder. If you don’t have detergent, you can use detergent.
4. For the traces of tape in other places, soak it in warm water with a rag and wipe the traces. Put the detergent in the watering can and spray some detergent while wiping. The offset will soon become soft.
How to remove the foam double-sided adhesive mark on the door
1. Take a piece of paper towel soaked in vinegar and stick it on the double-sided foam tape to allow the vinegar to fully penetrate the double-sided foam tape. It takes about 3 to 4 minutes. Then gently peel it off, and the offset will naturally fall off. This will not have any effect on the door, and finally wipe it dry with a paper towel. (Vinegar does not need too much, it is enough to wet the double-sided foam tape.)
2. Similarly, the imprint on the door can also be blown with a hair dryer to heat the remaining part of the foam double-sided tape, and it can be easily removed.
3. If the offset printing area is relatively large, it can be removed with gasoline. The removal speed should be fast. The gasoline will evaporate after a long time, so there is no need to worry about residue.
How to remove the traces of transparent glue
1. Eraser Eraser is really omnipotent. It can remove a lot of traces. For the traces of transparent glue, try repeatedly and slowly.
2. Dishwashing detergent takes a long time, and it is difficult to remove the general offset printing. Dip a towel with warm water and apply it on it. After it is fully penetrated, slowly wipe off the offset printing. (Don’t use this method in damp or leaky places)
3. Alcohol Use alcohol to gently wipe back and forth several times, you can also wipe clean the transparent glue marks, pay attention to safety when using alcohol, if you are afraid of fading, it is not recommended to use alcohol.
4. Nail polish remover For small offset printing areas, you can use nail polish remover to wipe off, the chemical composition in the nail polish remover can remove the offset printing.